Hot Sale Boilers
GET 20%OFF √
Available fuel：Nature gas, methanol, liquid propane gas, diesel, heavy oil, light oil, crude oil, etc.
Available industries：Heat supplying, chemical, food, textile, printing and dyeing, cigarettes and tobacco, fodder, pharmacy, building materials, brewery, rubber, hospital etc.
Please email or call us for your inquiry
2011/11/8 · The inlet steam pressure is 2.35 MPa, which is higher than conventional. A triple-flash system is employed to utilize the geothermal energy most effectively. The water after separation of the steam is flashed in two stages, and the generated steam is led to the IP and LP parts of the turbine, to maximize the output.Get price
heat recovery steam generator (HRSG) design for achieving higher efficiency. Figure 2 shows the gas and steam conditions in the boiler on temperature- enthalpy diagram. The enthalpy rise between the feed water inlet and steam outlet must equal theGet price
The Steam Generator gets its feedwater directly from this tank. Raw makeup water and low temperature condensate are fed to a second atmospheric "makeup" tank (a "hotwell"). Then it is transferred via a high pressure transfer pump to the SCR tank.Get price
Sheet 2. Chapter 3: Steam Generator Boiler, Classification of Steam Generators: FIRE-TUBE Boilers, WATER-TUBE Combined type, Steam Temperature Control, Heat Balance of Steam DesuperheaterGet price
2022/1/2 · In the Gavin Power Plant, each generating system has a single-stage feedwater pump driven by a steam turbine, as shown below. Its purpose is to pump the condensed saturated-liquid water at 800 kPa, 170°C to a high pressure of 30 MPa at the inlet to the boiler. The pump is powered by a dedicated 48.49 MW (65,000 hp) turbine.Get price
The outlet steam rate from the boiler is (3.95 kg/kW.hr) at (40 bar, 350 Co). The inlet boiler feed water temperature is (165 Co saturated). The boiler efficiency is (88%). The steam is expanded in the first stage of the turbine until it is dry at (30 bar), then it is reheated to (350 Co). (8%) of steam is extracted from the first stage of theGet price
Water flows down backside Steam/water flows up front Feed Water Inlet Steam drum Generating Bank Economizer Circulation in Two-Drum Boiler Top drum is a steam-water separator Hot feedwater enters – steam leaves Generating bank is its own naturalGet price
Steam generators are very rapid acting (produce steam within seconds). Superheated steam often leads to a reduction in the number of boilers, a reduction in the feed water usage, reduction in boiler load, improvement in the process timing, a reduction in the reagents, and emulsification with a overall better yield.Get price
2. Turn off the energy source inlet (steam, boiler water, or high temperature water) valve(s). 3. Turn off the energy source (steam, boiler water, or high temperature water) return valves. 4. Turn off the clean steam and condensate outlet valves. 5. Turn off feedGet price